Small Bluetooth amp boards are the heart of most DIY portable speakers. The differences that matter in practice are input voltage, real power and what you’re driving. Figures below come from seller listings, so confirm them on the page you buy from.
| Board | Output | Input | Good for | Watch for |
|---|---|---|---|---|
| ZK-502C | 2×50 W | 5–27 V | Small builds with flexible power | Full power needs about 18 V or more |
| MakerHawk TPA3116D2 | 2×50 W | 12–24 V | General-purpose 4 in to 6.5 in builds | Check the listed voltage range |
| DollaTek mini | 2×50 W | 18–24 V | Compact metal-case builds | A 4S pack is too low. Use 6S or a tool battery |
| Hosyond 200 W | 2×100 W | 12–24 V | Large drivers and loud use | Full power needs 24 V and a strong supply |
| TPA3110 | 2×15 W | 8–24 V | Small, cool, efficient mini speakers | Limited headroom in larger boxes |
| PAM8403 | 2×3 W | 3.7–5.5 V | USB-powered pocket speakers | Quiet in anything bigger than 1 L |
| TPA3255 | 2×100 W | 18–48 V | High-power builds on a 6S pack | Overkill for small drivers |
Start with the driver. Pick an amp whose per-channel power is at or below the driver’s RMS rating, so a turned-up volume can’t overdrive it. Then check the minimum input voltage against the battery’s empty voltage. Finally check impedance: these boards expect 4 Ω or higher. Some builders also report a faint hiss at idle on cheap TPA3116 boards, so keep returns in mind.