Drivers need enough air behind them, and the battery and amp take some of it. Measure the inside of the box, then subtract what you put in it.
Internal volume in litres = length × width × height in centimetres ÷ 1000. A box 25 × 17 × 12 cm inside is 5.1 L. In inches, multiply length × width × height by 0.0164. Subtract the battery (a 4S2P 18650 pack is about 0.3 L), the amp and wiring (about 0.1 L), and about 0.15 L per driver magnet. The planner assumes 1.5 L for electronics and wiring, which is conservative.
| Case | Approx. interior |
|---|---|
| Pelican 1200 | 3 L |
| Apache 2800 | 5 L |
| M2A1 .50 cal ammo can | 5 L |
| Pelican 1400 | 7 L |
| Apache 3800 | 8 L |
| Pelican 1450 | 9 L |
| Apache 4800 | 15 L |
| Pelican 1550 | 20 L |
These are approximations. Measure your own case.
Small full-range builds are usually sealed: simpler, tighter bass and less to get wrong. A ported box adds output near its tuning frequency but needs the port length calculated for the box volume and driver.
Print with 4 or more perimeters at 3 to 4 mm wall thickness so the panels don’t resonate. Use PETG or ASA: PLA softens around 55 to 60 °C, which a closed car can reach. Add heat-set inserts for screws, a foam or silicone gasket on the lid, and seal seams so the box is airtight. Large boxes can be split into panels to fit the print bed. Useful items: PETG filament, heat-set inserts.